Question about VIVE's Marker-Based Drift Prevention

[VIVE_Sally]

The settings for the batch configuration is correct.

To make sure whether the function is enabled for the headset, please check the Batch configuration of the settings section on the device page on VB+, the name of the batch configuration will be shown on the list with a green check mark if successfully applied.

[EmilioBlackBird]

Thank you, we have another question.

If we choose Drift Prevention and we make a new map, will the relocation marks continue to work together with the Drift Prevention marks?

[VIVE_Sally]

these functions are independent, if you choose Drift Prevention only, than only the markers set for Drift prevention will work.

note that markers set for Drift Prevention could also be used for Advanced Relocation only if the function is enabled.

[EmilioBlackBird]

So, the drift prevention markers do they also act as a relocation? Can I have both functions at the same time?

[VIVE_Sally]

yes, they works for both funcitons.

marker functions for LBE could all be used at the same time. (MBDP/MBR/MBSA)

[EmilioBlackBird]

Then I must make new marks, because I have four for Drift and two for Recolocation. They don't use the same json, do they?

I have to make six new ones for Drift with the same json and all six will do both Drift and Recolocation. Do they?

[VIVE_Sally]

The HMD only works with one json file when creating the map, so you'll have to generate One Json with all the markers you need.

[Illusion Walk]

You dont have to print and put up new markers. use the marker generation tool and put in the marker numbers and data of the markers you have and then just use the new json.

 

i m just getting a new question: we always made a json for mbsa and another json for mbdp/mbrl. should these markers be created in one go so that they are in the same json file?