[Tracker Advice]

At the moment in beat saber I don't get any outputs at all from pin 1 (digital output) - any way to resolve this?

[Tracker Advice]

Hi all - sorry for the newbie questions but hoping someone can assist me.

 

1. I recently aquired some trackers (2018) and was looking to wire up inputs/haptic feedback with them.

I was under the impression that pin 0 output has now become a lower voltage signal pin, with the intention of triggering a transistor, that requires me to use a different power source to actually drive the haptic feedback motor. Is this at all possible from the Pogo pins - if not is it possible through the micro usb on the tracker? (5v?) or failing that do I require a seperate power source for my motor?

 

2. Should I be using the most recent official firmware on the trackers or is there better beta firmware - or even old firmware that is preferable?

 

3. Is it possible to then configure this using Steamvr or should I be looking to use 3rd party input emulators?

 

Thank you for any/all advice! =)