Jump to content

Firmware update Issues

Rabid Gerbil

Recommended Posts



I Just updated the firmware on my 2 Base Stations. The first one said Update Installed Successfully, so I updated the 2nd, again no issues. I mounted and plugged the second station and it turned on as normal, green light and channels and the 9 little red lights in a square. However, when I mounted and plugged the first one back in, there was no light turning on at all. its like there was no power. 


I know the power cable was fine as I had just used it on the other base station and there were no issues.

I tried resetting the firmware back to "lighthouse_tx_htc_2_0-calibration-rescue-244.bin" and "lighthouse_tx_htc_2_0-factory-reset-rescue-244.bin" and now I have a little green light constantly blinking.


I have both stations set to the correct channels B + C, they can both see eachother without issue.


Please help!!!

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...